How is a voltmeter connected in the circuit to measure the potential difference between two points?
ScienceClass 10CBSEAnswered 27 Mar 2026
Answer
Solution:
To measure the voltage between any two points, the voltmeter should be connected in parallel between the two points.
Suggested Q&A
Science · Class 10- ScienceClass 101. How does refraction take place in the atmosphere? Why do stars twinkle but not the planets?
- ScienceClass 101. How can we explain the reddish appearance of sun at sunrise or sunset? Why does it not appear red at noon?
- ScienceClass 10Define the principal focus of a concave mirror.
- ScienceClass 10Explain the following. a. Why is the tungsten used almost exclusively for filament of electric lamps? b. Why are the conductors of electric heating devices, such as bread-toasters and electric irons, made of an alloy rather than a pure metal? c. Why is the series arrangement not used for domestic circuits? d. How does the resistance of a wire vary with its area of cross-section? e. Why copper and aluminium wires are usually employed for electricity transmission?
- ScienceClass 10An electric heater of resistance 8 Ω draws 15 A from the service mains 2 hours. Calculate the rate at which heat is developed in the heater.
- ScienceClass 10Which uses more energy, a 250 W TV set in 1 hr, or a 1200 W toaster in 10 minutes?
- ScienceClass 10Two conducting wires of the same material and of equal lengths and equal diameters are first connected in series and then parallel in a circuit across the same potential difference. The ratio of heat produced in series and parallel combinations would be _____. (a) 1:2 (b) 2:1 (c) 1:4 (d) 4:1
- ScienceClass 10An electric bulb is rated 220 V and 100 W. When it is operated on 110 V, the power consumed will be _____. (a) 100 W (b) 75 W (c) 50 W (d) 25 W
- ScienceClass 10Which of the following does not represent electrical power in a circuit? (a) I2R (b) IR2 (c) VI (d) V2/R
- ScienceClass 10A piece of wire of resistance R is cut into five equal parts. These parts are then connected in parallel. If the equivalent resistance of this combination is R′, then the ratio R/R′ is _____. (a) 1/25 (b) 1/5 (c) 5 (d) 25